Installation

The 4 foot Aerohead is pretty BIG!!....You'll need four hands and a little patience to get it right. The 2 footer only requires two hands...maybe four if ya lil clumbsy!
STEP 1: PICK THE PERFECT SPOT TO SHOW IT OFF.
Aerohead is not afraid to be too big for some walls so don't forget to measure before you install. Your Aerohead doesn't like textured surfaces. An interior painted drywall surface is always best! Ideal installation surfaces are listed on this sheet.
STEP 2: CLEAN THE WALL.
It is vital that you clean the wall thoroughly and allow it to dry completely before application of the Aerohead. Use a warm damp cloth. Do NOT use any cleaning chemicals or soap as this can affect the integrity of the adhesive.
STEP 3: PEEL, STICK IT UP, and SMOOTH IT OUT.
Unroll your Aerohead and allow some time for it to flatten out prior to applying it to the wall. (A razor blade may be necessary to get the peeling process started). If your Aerohead came in two parts, install the bottom half first. With someone on either side of the Aerohead, start on the left or the right edge and slowly and evenly peel toward the other direction. Be very careful of small/thin pieces like wing tips and landing gears as they may become torn if you peel too fast. For 4 footers, working together, slowly peel the paper backing off as you apply the Aerohead on the wall.(use minimal pressure) Use your hand to evenly smooth out the aircraft. Use a squeegee or straight edge (like a hard back book) and smooth the exposed area to the wall. Next, working from the center to the outside of the Aerohead, smooth out any bubbles and wrinkles. For a two piece Aerohead, carefully line up the top half with the bottom, smooth it out and then remove any bubbles your straight edge.
STEP 4: KICK BACK & ENJOY - YOU ARE CLEARED FOR TAKEOFF!
NOTE: If the Aerohead has some slicing of the backing paper, don't sweat it, it's NOT a product defect. Also, the edges of the sheet of that your Aerohead comes on may become wrinkled during shipping - this will not affect the quality of the Aerohead. Aeroheadz are designed for indoor use only. Your Aerohead should not be installed on a newly painted wall surface - most painted surfaces need a minimum of 30 days to completely cure.
Questions? Call